Tine Holders

DESCRIPTION :

Twin Tine Holder

SPIGOT CLAMP no.
DRAWBOLT no.

SC212, SC258, SC234, SC278 DB212, DB258, DB234, DB278

SOCKET SIZE :

½" 5/8" ¾" 7/8"

AERATION PATTERN :

3" x 3"(Minimum Uniform)

RECOMMENDED USE :

Generally used with the larger tines i.e. ¾" 5/8" or ½" where the wider hole spacing is desirable. Twin holders are also useful to achieve maximum depth where conditions are very hard and compacted. The choice of tine would depend on the severity of the compaction, i.e. the finer the tine the easier it would be to achieve full penetration. Twin holders are available in all four-socket sizes including the recently introduced 7/8" sck. for Jumbo Hollow Tines.

DESCRIPTION :

Triple Tine Holder

SPIGOT CLAMP no.
DRAWBOLT no.

SC312, SC358, SC334
DB312, DB358, DB334

SOCKET SIZE :

½" 5/8" ¾"

AERATION PATTERN :

2" X 2" (Minimum Uniform)

RECOMMENDED USE :

Normally used with the medium sized tines i.e. ½" or 7/16" although the smaller micro tines can be used where conditions are compacted or the pattern produced is desirable. The 1 ½" slit or 5/8" hollow and solid tines are generally not recommended for use in triples and certainly used only if conditions are soft and an exceptionally large amount of soil is to be removed or disturbed. This holder is available in three socket sizes therefore all tines except 7/8" socket jumbos will fit.

DESCRIPTION :

Quadra & Quint Tine Holder

SPIGOT CLAMP no.

SC412, SC512

SOCKET SIZE :

½" & ½"

AERATION PATTERN :

1 ½" 1 ¼"

RECOMMENDED USE :

Normally used only with the smaller tines, i.e. 3/8" and 5/16" for micro hollow and solid tining including needles all of which fit the ½" socket. The Quint Holder can also be used for over-seeding preparation or thatch removal.